Steel cap and collet firmly grip drill blades with no spinning!
Two collets cover a range of 0.1 to 3.2 mm in diameter!
GodHand’s original color rubber grip is included.
The rubber grip provides an easy grip with no stress on the fingers and prevents fatigue even after long hours of use.
The cap and chuck are steel-made. Two collet chucks cover a wide range of drill blades. Made of high-strength steel, it grips a drill tightly and will not slip or spin around with thin or thick drill blades.
Steel collet is wear-resistant and holds drill blade firmly without idling.
Ideal for fine-size drilling and deburring!
GodHand original blue grip
Steel cap and chuck adopted.
Grips thin or thick drill blades firmly without spinning.
Capable of drilling from 0.1mm to 3.2mm dia. by replacing the collet chuck.
Power Pin Vise
■Product Code：GH-PB-98ST
●Quality Indication
・Total length: approx. 100 mm
・Material: Iron (tip cap, collet chuck), brass (body)
・Collet capacity: 0.1 – 3.2 mm dia. (by replacing collet chuck)
⚠NOTE
・Please be careful not to cut your fingers when putting in and out the blades (drills, etc.).
・Please tighten the cap firmly before use.
・Please use a blade that matches the collet size.
・Please wear protective glasses during use.
・Please keep out of reach of children.
