Matho Models Vintage Soft Drink Logo Waterslide Decals
Matho Models 80022 provides an A6 sheet of waterslide decals featuring vintage logos from popular soft drinks. Each type of logo is supplied in different sizes, giving you a useful selection for adding vintage soft drink branding to scale modelling projects across a variety of scales.
The decals feature separated film, allowing individual logos to come away one by one without the need to cut precisely to their edges. Their ultra-thin construction helps them adapt well to different surfaces, while the semi-matte finish provides a controlled appearance. High-definition printing produces crisp results even in the smallest details, with accurate and colourfast printing.
Vintage Soft Drink Logos in Different Sizes
The A6 sheet combines various vintage soft drink logos, with different sizes available for each type. This makes the set suitable for all scales and provides flexibility when selecting a logo size to suit an individual design. The combination of vintage branding and varied sizes makes this detailing accessory useful wherever these distinctive soft drink markings are required.
Produced by Matho Models, the sheet uses individually separated decal film, so each chosen logo can be handled separately during application.
Applying the Waterslide Logo Decals
Cut out the required decal with a sharp knife and place it in water for approximately 5 to 10 seconds to loosen it from the carrier paper. Gently slide the logo into position using tweezers. Decal softener, such as Micro Set and Sol, can be used for better adhesion, particularly when applying a decal to a non-flat surface.
Once positioned, use tissue paper and apply light pressure over the decal to remove excess water or decal softener and fix the logo in place. Varnish can then be airbrushed over the decal for protection. Semi-matte or matte varnish can be used to reduce glare if required. The usual weathering process can then be applied to blend the vintage soft drink logo into the finished design.
