Sturdier and much easy-to-use than Ultimate Nipper!
For beginners of single-blade nipper!
Blade One Nipper is an entry-level single-blade nipper.
Blade One nipper has a thicker blade than Ultimate Nipper, resulting in a slightly pressed cutting surface on the cutting board side, but it is sturdier due to the thickness of the blade.
Single-edged blade structure enables the same usage as Ultimate Nipper.
The blade angle is adjusted to make the blade more durable than that of the Ultimate Nipper.
While Ultimate Nipper can cut transparent plastic up to 1 mm dia., Blade One Nipper can cut transparent plastic up to 2 mm dia.
The cut comfort is slightly heavier than Ultimate Nipper, but there is almost no difference in the cut surface in slice-cutting.
Blade One Nipper
■Product Code：GH-PN-120
●Quality Indication
・Material: Special tool steel (made by Kobe Steel, Ltd.)
・Total length: approx. 120 mm
・Weight: approx. 60 g
・Blade hardness: ≧ HRC58
・Single-edge specification
・Blade breakage prevention stopper
・Over-opening prevention pin
・Spring loaded
・Soft grip
・With original nipper cap
●Cutting capacity
・Target materials: Plastic (PS resin, PP resin, ABS resin, PE resin) only
・Cutting capacity: Materials of < 3 mm dia. However, transparent and translucent PS resins are limited to < 2 mm dia for hardness.
⚠NOTE
・The nippers are delicate and sharp. If misused, the blades may chip or break.
・The blade can cut plastics with ease and precision. Please do not grip the nippers with excessive force.
・The blade is thinner toward the tip and is more likely to break. Please cut as close to the center of the blade as possible.
・Please do not twist the blade during cutting or releasing from the runner. Twisting may cause it to break under load.
・Please do not cut plastics that are too long for the blade. The load will be applied to one point, causing it to break or bend.
・Please do not use for cutting plastics that exceed the cutting capacity or materials that are not compatible (metal, resin, paper, and other materials besides plastic).
・Please do not use cutting materials such as plastic plates, tags, parts, or dowels.
・Please remove chips from the blade with a toothbrush (a blade brush) during and after use.
Cutting with chips remaining on the blade may cause excessive load and damage.
In particular, cutting with chips stuck in the base of the blade can easily cause misaligned.
・Please do not touch the cutting edge directly. The cutting edge is sharp and may get injured.
・Sebum may cause rust. If you touch the metal parts directly, wipe off any fingerprints and dirt, and apply rust-preventive oil.
・Humidity may cause rust. Please oil more often, even during the rainy season.
・Poor lubrication of moving parts causes wears on the shaft and rattling, leading to reduced sharpness. Please lubricate the moving parts regularly.
・Please wear protective glasses for safety.
・Cutting materials may fly away. Please be sure no one or fragile objects are around before use.
・Please keep out of reach of children.
・Please put on the attached nipper cap for safekeeping.
